Assigning The Voip Lan Ip Address; Web Interface - AudioCodes MediaPack Series MP-11x User Manual

User's Manual
2

Assigning the VoIP LAN IP Address

The device is shipped with a factory default IP address for its operations, administration,
maintenance, and provisioning (OAMP) VoIP LAN interface, as shown in the table below:
IP Address
IP Address
Subnet Mask
Default Gateway IP
Address
The default IP address can be used for initially accessing the device, using any of its
management tools (i.e., embedded Web server, EMS, or Telnet). Once accessed, you can
change this default IP address to correspond with your networking scheme in which the
device is deployed. After changing the IP address, you can re-access the device with this
new LAN IP address and start configuring and managing the device as desired.
This section describes the different methods for changing the device's default IP address to
suit your networking environment:

Embedded command line interface (CLI) - see 'CLI' on page

Embedded HTTP/S-based Web server - see 'Web Interface' on page

Bootstrap Protocol (BootP) - see BootP/TFTP Server on page

FXS telephone voice menu - see FXS Voice Menu Guidance on page
2.1

Web Interface

The procedure below describes how to assign a LAN IP address using the Web interface.

To assign an IP address using the Web interface:
1. Disconnect the network cables (if connected) from the device.
2. Connect the Ethernet port located on the rear panel (labeled Ethernet) directly to the
network interface of your computer, using a straight-through Ethernet cable.
Figure 2-1: MP-11x LAN Connection to PC for Initial Connectivity
Version 6.6
Table 2-1: Default VoIP LAN IP Address

FXS and FXS / FXO devices: 10.1.10.10

FXO device: 10.1.10.11
Note: FXO interfaces are applicable only to MP-11x series devices.
255.255.0.0
0.0.0.0
23
2. Assigning the VoIP LAN IP Address
Value
26
25
MP-11x & MP-124
23
27