Fax Settings; Setting Sending/Receiving Start Speed - Canon imageRUNNER 2545i System Settings Manual

<Divided TX over Max.Data Size>:
[On]: When the data size of the document exceeds the size set in <Maximum TX Data
[Off]: When the data size of the document exceeds the size set in <Maximum TX Data
<Default Subject>:
Press [Subject] ➞ enter the default subject ➞ press [OK].
You can enter up to 40 characters for the default subject.
IMPORTANT
• Be sure to set the maximum data size for sending to a value that does not exceed the
maximum data size allowed by the mail server.
• If the Language Switch setting is set to 'On', some characters are restricted and
4
cannot be entered. To enter all characters, set the Language Switch setting to 'Off'.
(See Chapter 3, "Configuring the Machine's Basic Settings," in the Reference Guide.)
NOTE
• You can also enter values for Maximum TX Data Size using
• For instructions on how to enter characters using the on-screen keyboard, see
Chapter 2, "Basic Operations," in the Reference Guide.
4
Confirm the settings you specified ➞ press [OK].
5
Press

Fax Settings

Setting Sending/Receiving Start Speed

This section describes how to set the send and receive start speeds. This is useful
when there is difficulty initiating the sending and receiving of a document.
IMPORTANT
This setting is available only when the optional Super G3 Fax Board-AG1 is attached
to the machine.
NOTE
The default setting is '33600 bps' for both the Send Start Speed and Receive Start
Speed.
4-4
Specifying Communications Settings
Size>, the document is sent as separate files. If the data size of a single page
document exceeds the maximum data size for sending, the send job is handled
as an error and the document cannot be sent.
Size>, the document is not sent.
(Reset) to return to the top screen.
- (numeric keys).