Memory Lock Settings - Canon imageRUNNER 2545i System Settings Manual

Memory Lock Settings

There may be occasions when you want to use the Memory Lock mode, which
stores all incoming documents in the memory until you are ready to print or send
them. After the Memory Lock is turned 'On', the machine will enter the Memory
Lock mode. The documents received when the machine is in the Memory Lock
mode are stored in memory until you unlock the memory with a password and print
them. You can also set the machine to automatically enter and leave the Memory
Lock mode at a specified time.
4
This section explains how to enable and disable the Memory Lock mode and
configure the Memory Lock settings such as the password and the timer for turning
on and off the Memory Lock.
IMPORTANT
• This setting is available only when the Send function (optional for the imageRUNNER
2545/2535/2530/2525/2520) is activated or the optional Super G3 Fax Board-AG1 is
attached to the machine.
• Additional documents cannot be received in memory if either of the following is true:
- When a total of 95 documents have been stored
- When a total of approximately 1,000 pages have been stored
NOTE
• You can check, erase, or redirect the received documents in memory using the
System Monitor screen. (See Chapter 6, "Checking/Changing the Status of
Documents in Memory," in the Sending and Facsimile Guide.)
• The default setting is 'Off'.
4-8
Specifying Communications Settings
Memory
I-Fax Reception
Send
Print
Fax Reception