Interface Settings (Ethernet Driver) - Canon imageRUNNER 2545i System Settings Manual

Interface Settings (Ethernet Driver)

After physically connecting the machine to a network, you must specify the
communication mode (Half duplex/Full duplex) and Ethernet type (10BASE-T/
100BASE-TX). You can also set the machine to automatically select these settings.
2
IMPORTANT
• If you are configuring the interface settings for the first time, use the machine's control
panel. After configuring the protocol settings, you can change the content by using the
Remote UI. For instructions, see the Remote UI Guide.
• Changes made to Interface Settings become effective when the machine is restarted.
To restart the machine, turn it OFF, wait at least 10 seconds, and then turn it ON. For
instructions on how to turn the machine ON and OFF, see Chapter 2, "Before You Start
Using the Machine," in the User's Guide.
1
2
2-2

Interface Settings (Ethernet Driver)

Press (Additional Functions)
➞ [System Settings] ➞ [Network
Settings].
Press until [Ethernet
[ ] or [ ]
Driver Settings] appears ➞ press
[Ethernet Driver Settings].