3
Specify the communication mode.
● If you want the machine to automatically determine the communication
mode (Half duplex/Full duplex) and Ethernet type (10BASE-T/
100BASE-TX):
● If you want to manually specify the communication mode (Half duplex/
Full duplex) and Ethernet type (10BASE-T/100BASE-TX):
IMPORTANT
Connect the cable with the power OFF. Even when you set <Auto Detect> to 'On', the
Auto Detect function will not work correctly if you reconnect the network cable (for
example, to a different Ethernet hub) with the power ON.
NOTE
• The default setting is 'On'. Use the [Off] setting when you want to specify a particular
Ethernet setting.
• The above screen also allows you to check the machine's MAC address.
❑
Press [On] for <Auto Detect>.
❑
Press [Off] for <Auto Detect>.
❑
Press [Half Duplex] or [Full Duplex] for
<Communication Mode>.
❑
Press [Full Duplex] if you want to
alternately send and receive. Press [Half
Duplex] if you want to simultaneously
send and receive.
❑
Press [10 Base-T] or [100 Base-TX] for
<Ethernet Type>.
Interface Settings (Ethernet Driver)
2
2-3