Unix/Linux - Canon imageRUNNER 2545i System Settings Manual

IMPORTANT
• To use [Full computer name], which was confirmed in step 4, as the host name for
[Host Name] as shown in the above example, it is necessary to use a DNS server.
(This applies even if the machine and the FTP server are in the same subnet.) If no
DNS server is available, the host name setting should be specified using the IP
address of the FTP server.
• Up to 47 alphanumeric characters can be entered for [Host Name] and 120 characters
for [File Path] on the touch panel display.
• If you switch the language of the touch panel display, [Host Name] and [File Path] may
not be displayed correctly.
NOTE
For instructions on how to specify recipient address settings, see Chapter 2, "Sending
Documents," in the Sending and Facsimile Guide.

UNIX/Linux

IMPORTANT
5
• UNlX users must have Solaris 2.6 or later installed in order to use the computer as an
FTP server. Linux users must have Red Hat Linux 7.2 or later installed in order to use
the computer as an FTP server.
• In some environments, detailed settings may be required in order to use FTP. For
details, consult your network administrator.
1
Log in to a workstation as a superuser.
2
Set up the users who send documents from the machine, and their
passwords.
Enter a user name and a password not longer than 24 alphanumeric characters.
3
Create a shared directory to be used for recipient addresses, and
then enable read access and write access by the users who will be
sending data.
5-12
Setting File Server (FTP)