Maintenance
Loosen lock nut 1, remove snap pin and washer, and then
6.
remote control cable joint. (Throttle lever is not shown to
make the working procedure more comprehensible.
Adjust remote control cable length so that the cable joint 2
7.
hole aligns with set pin.
Screw-in remote control cable joint at lease
10mm a.
Adjust remote control cable joint with remote
control cable fully pushed in.
Reconnect remote control cable joint 1, attach snap pin 3,
8.
and tighten lock nut.
9.
Check if gear shifts smoothly, and repeat steps 2. to 8. as
necessary.
3-28
WARNING
1
2
a
1
3
4st 9.9/15/20 2008