Adjust screw-in length of cable joint i so that hole of cable
13.
joint e is brought to throttle lever and shift arm pin r.
After adjusting remote control cable joint, fix it
with remote control cable fully pushed in.
Screw-in remote control cable joint at lease
10mm i.
Lock cable joint with nut t, attach it to pin, and then, fix with
14.
washer y and snap pin u.
Check that shifting control lever forward (F) c by
15.
approximately 32 degrees (j), where it is stopped once,
makes the gear engage, and then, fully shifting the lever
makes throttle valve fully open Then, check that shifting the
lever reverse (R) d by approximately 32 degrees (j), where
it is stopped once, makes the gear engage, and fully shifting
the lever makes throttle valve fully open.
16.
Check if throttle valve operates smoothly, and repeat steps
1. to 16. as necessary.
4st 9.9/15/20 2008
CAUTION
r
e
e
i
u
y
c
3
t
d
3-25