Inspection Of Neutral Switch (Tiller Handle Model); Inspection Of Start Switch (Tiller Handle Model) - TOHATSU MFS 9.9 Owner's Manual

Electrical System
4. Apply pressure slowly with vacuum/pressure gauge.
5. Check that oil pressure switch is not conductive with
specified pressure applied. Replace if conductive.
Specified Pressure :
0.020 - 0.029 MP(2.8 - 4.0 psi) [0.2 - 0.3 kgf/cm
6. Reinstall the part.
Uses tapered threads — Do not overtorque or
powerhead could be damaged.
Oil Pressure Switch :
8 N · m (6 lb · ft) [0.8 kgf · m]
7) Inspection of Neutral Switch
(Tiller Handle Model)
This test can be made without removing parts.
1. Check electrical conductivity of neutral switch. Replace if no
conductivity.
Switch Position
Released
Pushed b
8) Inspection of Start Switch
(Tiller Handle Model)
1. Check conduction of stop switch, and replace if not
conductive.
This test can be made without removing parts.
Switch Position
Released : OFF
Pushed : ON
8-16
Lead Wire Color
Green (G) Green (G)
a
Lead Wire Color
Green (G)
2 ]
Red (R)
b a
OFF
ON
4st 9.9/15/20 2008