54" Mower Deck Spindle Replacement; 54" Mower Deck Spindle Removal - Toro GT series Service Manual

MOWER DECK
54" Mower Deck Roller Adjustment
1. Place the deck lift lever in the lowest position.
2. Remove the clevis pin and hairpin cotter from the
deck roller brackets on the left and right sides of the
cutting deck (Fig. 874).
3. Position the deck roller brackets up or down through
the slots on the rear of the deck until desired position
is reached, then re-attach with the clevis pins and
hairpin cotters just removed.
IMPORTANT: Be certain that the left roller bracket
and the right roller bracket are set in the same
position.
7
7-38
Fig 874 PICT-7929
54" Mower Deck Spindle
Replacement
The following procedure was performed on the left hand
spindle assembly. The process is the same for all three
spindle assemblies.

54" Mower Deck Spindle Removal

1. Remove the mower deck from the tractor. Refer to
"54" Mower Deck Removal" on page 7-29.
2. Remove the deck belt from the mower deck. Refer to
"54" Mower Deck Belt Removal" on page 7-23.
3. Turn the mower deck over to access the underside
of the mower deck.
4. Block the mower deck blade and remove the nut
securing the mower deck blade to the spindle shaft
(Fig. 875).
Fig 875
GT Series Tractors Service Manual
PICT-7882