Toro GT series Service Manual page 186

10. Loosen the jam nut on the idler adjustment rod.
Turn the idler adjustment rod clockwise or counter-
clockwise to obtain the 1-3/8" (3.5cm) idler bracket
travel (Fig. 634).
A
Fig 634
A. Jam nut
11. Tighten the jam nut.
GT Series Tractors Service Manual
B
PICT-7693
B. Idler adjustment rod
GEAR DRIVE SYSTEM
12. Install the main pin through the adjustment rod, back
into the lockout bracket, then through the speed
control assembly. Install the jam nut onto the pin
(Fig. 635).
Note: Ensure the main pin is oriented so the hairpin
holes are positioned vertically.
A
D
Fig 635
A. Main pin
B. Adjustment rod
C. Lockout bracket
13. Install a washer onto the main pin (Fig. 636).
Fig 636
B
E
C
PICT-7699
D. Speed control assembly
E. Jam nut
PICT-7683
5-55
5