Toro GT series Service Manual page 138

pulleys (Fig. 448).
Fig 448
12. Remove the transmission drive belt from around the
crankshaft and remove it from above the steering
support bracket (Fig. 449).
Fig 449
GT Series Tractors Service Manual
GEAR DRIVE SYSTEM
Variable Speed Drive Belt Installation
1. Route the transmission drive belt through the steer-
ing support bracket and frame. Install the transmis-
sion drive belt around the crankshaft (Fig. 450).
Note: The belt routes between the steering shaft
and left side of the frame.
PICT-7649
2. Route the belt between the two idler pulleys on the
center double idler bracket (Fig. 451).
PICT-7498
Fig 450 PICT-7622
Fig 451 PICT-7649
5
5-7