HYDROSTATIC DRIVE SYSTEM
Neutral Adjustment
Before making a neutral adjustment, the transmission
must be warmed up for at least 10 minutes.
1. Loosen the 4 lug nuts securing the right rear wheel
to the wheel hub assembly (Fig. 712).
2. Raise and support the rear of the machine.
6
3. Remove the 4 lug nuts and remove the wheel as-
sembly from the wheel hub (Fig. 713).
6-22
Fig 712
PICT-7502a
Fig 713
PICT-7503a
4. Locate the neutral adjusting puck and loosen the
aluminum housing near the bolt with a propane torch
(Fig. 714).
Fig 714
5. Start the engine and run it at full throttle.
6. Rotate the adjusting puck in both directions and
7. Once in neutral, hold the puck with an adjustable
wrench so it won't move. Tighten the Allen head bolt
(Fig. 715).
Fig 715
GT Series Tractors Service Manual
PICT-7822
PICT-7823