Mitsubishi Electric FR-V560 Instruction Manual page 48

Setting
Signal
Positive Negative
Name
logic logic
Regenerative status
32 132 Y32
output
33 133 RY2 Operation ready 2
34 134 LS Low speed output
35 135 TU Torque detection
36 136 Y36 In-position
Maintenance timer
37 137 MT
output
Start time tuning
39 139 Y39
completion
40 140 Y40 Trace status
41 141 FB Speed detection
Second speed
42 142 FB2
detection
Third speed
43 143 FB3
detection
44 144 RUN2 Inverter running 2
96 196 REM Remote output
97 197 ER Minor fault output 2
98 198 LF Minor fault output
99 199 ABC Alarm output
9999 —— No function
0 to 99: Positive logic, 100 to 199: Negative logic
Function
For vector control
Output on completion of pre-excitation. Turned on at an output start when pre-
excitation is not made.
Output when the speed falls to or below any preset low speed.
Output when the motor torque rises above the predetermined value (Pr.864).
(Refer to page 194.)
Acts as an in-position signal.
Refer to Pr. 890 to Pr. 892 (maintenance output function) (page 199).
Output on completion of start time tuning
Acts as a trace completion signal.
Output when the motor output speed (feed back value) exceeds the preset
speed.
Perform in the same way as FU, FU2 and FU3 under V/F control.
• Output during forward operation or the reverse signal is ON.
• Output at deceleration even during forward rotation or the reverse signal is
OFF. (Does not output during pre-excitation LX is ON.)
• Output during the orientation command signal (X22) is ON.
• Switched ON when the servo is ON (LX-ON) under position cotrol. (Switched
OFF when the servo is OFF. (LX-OFF)
Refer to Pr. 495 to Pr.497 (page 181).
At occurrence of a major fault, the base circuit is shut off immediately. At
occurrence of a minor fault, the base circuit is shut off after deceleration to a
stop.
Output when a minor fault (fan fault or communication error alarm) occurs.
Output when the inverter's protective function is activated to stop the output (major
fault).
—
39
How to use the output signals (assigned terminals
DO1 to DO3, ABC) (Pr. 190 to Pr. 192, Pr. 195)
Operation
1