Sp Set Locatelight Subcommand; Format; Return Codes - Sun Microsystems Fire V20z Management Manual

SP Set Locatelight Subcommand

Description: Sets the state of the locatelight switch (which describes the state of the
front and rear panel identification lights).

Format

sp set locatelight {BLINK | OFF}

Return Codes

lists the return codes for this subcommand.
TABLE H-34
Return Codes for Subcommand sp set locatelight
TABLE H-34
Return Code
NWSE_Success
NWSE_InvalidUsage
NWSE_RPCTimeout
NWSE_RPCNotConnected
NWSE_NoPermission
ID Description
Command successfully completed.
0
Invalid usage: bad parameter usage, conflicting
1
options specified.
Request was issued, but was not serviced by the
2
server. RPC procedure timed out and the request may
or may not have been serviced by the server.
Unable to connect to the RPC server.
3
Not authorized to perform this operation.
6
Appendix H Service Processor Commands 239