Return Codes - Sun Microsystems Fire V20z Management Manual

If the state returned from the command is that the platform is up and ready for
diagnostics, then you can submit platform diagnostic tests for execution. You can
optionally start diagnostics on the SP from the NFS mount without rebooting the
platform into diags mode. This enables you to continue to run the production OS
while you simultaneously perform SP diagnostics testing.
To do so, run the diags start subcommand with the following option:
diags start --no platform
The platform state must be either off or OS Communicating. Refer to the platform
get os state subcommand for details about these states.

Return Codes

lists the return codes for this subcommand.
TABLE C-11
Return Codes for Subcommand diags start
TABLE C-11
Return Code
NWSE_Success
NWSE_InvalidUsage
NWSE_RPCTimeout
NWSE_RPCNotConnected
NWSE_InvalidArgument
NWSE_NoPermission
NWSE_NoRouteToHost
NWSE_InvalidOpForState
NWSE_ServiceNotAvailable
ID Description
Command successfully completed.
0
Invalid usage: bad parameter usage, conflicting
1
options specified.
Request was issued, but was not serviced by the
2
server. RPC procedure timed out and the request
may or may not have been serviced by the server.
Unable to connect to the RPC server.
3
One or more arguments were incorrect or invalid.
4
Not authorized to perform this operation.
6
No route to host (network down). Occurs when
13
CD Diagnostics is unable to send a packet to the SP
on a specific port.
Invalid operation for current state.
22
Requested service is not available.
24
Appendix C Diagnostics Commands 167