Sun Microsystems Fire V20z Management Manual page 242

TABLE G-4
TABLE G-4
Arguments
{-i | --id}
{-t | --type}
{-C | --crithigh}
{-c | --critlow}
{-W | --warnhigh}
{-w | --warnlow}
{-v | --value}
{-r | --reset}
{-R | --resetall}
218 Sun Fire V20z and Sun Fire V40z Servers—Server Management Guide • July 2005
lists the arguments for this subcommand.
Arguments for Subcommand sensor set
Description
Specifies the specific sensor on which to operate. You can specify
multiple sensors by repeating --id.
Specifies the specific sensor class on which to operate (for
example, fan, voltage and so on).
Specifies the critical high threshold value for the sensor.
• Setting the string to clear disables the threshold.
• Setting the string to reset sets the value to the original
factory-specified value.
• If the value specified ends in a percent sign (%), the threshold
is set to that percentage of the nominal value for the sensor.
• Any other value is interpreted as the actual value to which to
set the threshold.
Specifies the critical low threshold value for the sensor. Setting the
string to clear disables the threshold.
Specifies the warning high threshold value for the sensor. Setting
the string to clear disables the threshold.
Specifies the warning low threshold value for the sensor. Setting
the string to clear disables the threshold.
Sets the value of the sensor.
Resets all thresholds for the specified sensor(s) to the factory
defaults.
Resets all thresholds for all sensors to the factory defaults.