Sp Locate Light Subcommands; Sp Get Locatelight Subcommand; Format; Return Codes - Sun Microsystems Fire V20z Management Manual

SP Locate Light Subcommands

The subcommands in
TABLE H-32
Subcommand
sp get locatelight
sp set locatelight

SP Get Locatelight Subcommand

Description: Reads the value of the locatelight switch (which represents the state of
the front- and rear-panel identification lights). The possible states are blinking or off.

Format

sp get locatelight

Return Codes

TABLE H-33
TABLE H-33
Return Code
NWSE_Success
NWSE_InvalidUsage
NWSE_RPCTimeout
NWSE_RPCNotConnected
NWSE_NoPermission
238 Sun Fire V20z and Sun Fire V40z Servers—Server Management Guide • July 2005
TABLE H-32
SP Locatelight Subcommands
Description
Reads the value of the locatelight switch (which represents
the state of the front- and rear-panel identification lights).
Sets the state of the locatelight switch.
lists the return codes for this subcommand.
Return Codes for Subcommand sp get locatelight
ID
0
1
2
3
6
manage the locatelight switch.
Description
Command successfully completed.
Invalid usage: bad parameter usage, conflicting
options specified.
Request was issued, but was not serviced by the
server. RPC procedure timed out and the request
may or may not have been serviced by the server.
Unable to connect to the RPC server.
Not authorized to perform this operation.