Return Codes - Sun Microsystems Fire V20z Management Manual

lists the arguments for this subcommand.
TABLE H-30
Arguments for Subcommand sp set jnet
TABLE H-30
Argument
{-p | --platform}
{-s | --sp}
Note – If you change the default addresses of JNET using this command and then
re-install the platform OS or reset the SP through the subcommand
sp reset to default-settings , you must re-issue the subcommand
sp set jnet to re-establish the JNET connection.
Otherwise, the connection will be out-of-sync (one address will be modified and one
will be re-set to the default address.)

Return Codes

lists the return codes for this subcommand.
TABLE H-31
Return Codes for Subcommand sp set jnet
TABLE H-31
Return Code
NWSE_Success
NWSE_InvalidUsage
NWSE_NoPermission
NWSE_NoMemory
NWSE_Busy
NWSE_HostDown
Description
Specifies the IP address for the platform.
Specifies the IP address for the SP.
ID Description
Command successfully completed.
0
Invalid usage: bad parameter usage, conflicting options
1
specified.
Not authorized to perform this operation.
6
Insufficient memory.
8
Device or resource is busy.
9
Host is down.
14
Appendix H Service Processor Commands 237