Profile Services Configuration - Motorola WiNG 5 System Reference Manual

5 - 134 WiNG 5 Access Point System Reference Guide
Mode
VLAN
11. Select the
12. Set the duration between two successive pings from the access point to critical resource. Define this value in
seconds from 5 - 86,400. The default setting is 30 seconds.
13. Select OK
to the last saved configuration.

5.3.9 Profile Services Configuration

A profile can contain specific guest access (captive portal) server configurations. These guest network access
permissions can be defined uniquely as profile requirements dictate.
To define a profile's services configuration:
Set the ping mode used when the availability of a critical resource is
validated. Select from:
• arp-only – Use the Address Resolution Protocol (ARP) for only pinging the
critical resource. ARP is used to resolve hardware addresses when only
the network layer address is known.
• arp-and-ping – Use both ARP and Internet Control Message Protocol
(ICMP) for pining the critical resource and sending control messages
(device not reachable, requested service not available, etc.).
Define the VLAN on which the critical resource is available using the spinner
control.
Monitor Interval tab.
Figure 5-76 Critical Resources screen - Monitor Interval tab
to save the changes to the critical resource configuration and monitor interval. Select Reset to revert