Table of Contents
Advertisement
5 - 202 WiNG 5 Access Point System Reference Guide
Use DHCP to Obtain IP
Use DHCP to obtain
Gateway/DNS
Servers
Secondary Addresses
12. Define or override the
Select either the Inside, Outside or None radio buttons.
• Inside - The inside network is transmitting data over the network its intended destination. On the way out, the
source IP address is changed in the header and replaced by the (public) IP address.
• Outside - Packets passing through the NAT on the way back to the LAN are searched against to the records
kept by the NAT engine. There the destination IP address is changed back to the specific private class IP
address in order to reach the LAN over the switch managed network.
• None - No NAT activity takes place. This is the default setting.
13. Select
OK
the last saved configuration.
14. Select the
Select this option to allow DHCP to provide the IP address for the Virtual
Interface. Selecting this option disables the Primary IP address field. AP-7131,
AP-6532 and AP-7161 have on onboard DHCP server resources, while AP-6511
and AP-6521 models do not.
Select this option to allow DHCP to obtain a default gateway address, and DNS
resource for one virtual interface. This setting is disabled by default and only
available when the Use DHCP to Obtain IP option is selected. AP-7131,
AP-6532 and AP-7161 have on onboard DHCP server resources, while AP-6511
and AP-6521 models do not.
Use the Secondary Addresses parameter to define additional IP addresses to
associate with VLAN IDs. The address provided in this field is used if the
primary IP address is unreachable.
Network Address Translation (NAT)
NOTE: Refer to
Setting the Profile's NAT Configuration on page 5-114
creating a profile's NAT configuration.
button to save the changes and overrides to the Basic Configuration screen. Select
Security
tab.
direction.
for instructions on
Reset
to revert to
Hide quick links:
Advertisement
Table of Contents
