Motorola WiNG 5 System Reference Manual page 676

13 - 70 WiNG 5 Access Point System Reference Guide
Good Pkts
Received
Mcast Pkts Sent
Mcast Pkts
Received
Bcast Pkts Sent
Bcast Pkts
Received
Packet
Fragments
Jabber Pkts
8. The Errors
Bad Pkts
Received
Collisions
Late Collisions
Excessive
Collisions
Drop Events
Tx Undersize
Pkts
Oversize Pkts
MAC Transmit
Error
MAC Receive
Error
Bad CRC
Describes the number of good packets received.
Displays the number of multicast packets sent through the selected interface.
Displays the number of multicast packets received through the selected
interface.
Displays the number of broadcast packets sent through the interface.
Displays the number of broadcast packets received through the interface.
Displays the number of packet fragments transmitted or received through the
interface.
Displays the number of packets transmitted through the interface that are
larger than the MTU through the interface.
field displays the following information for the selected access point interface:
Displays the number of bad packets received through the interface.
Displays the number of collisions on the interface.
A late collision is any collision that occurs after the first 64 octets of data
have been sent by the sending client. Late collisions are not normal, and are
usually the result of out-of-specification cabling or a malfunctioning device.
Displays the number of excessive collisions. Excessive collisions occur when
the traffic load increases to the point that a single Ethernet network cannot
handle it efficiently.
Displays the number of dropped packets transmitted or received through the
interface.
Displays the number of undersize packets transmitted through the interface.
Displays the number of oversize packets.
Displays the number of transmits that failed because of an internal MAC
sublayer error that is not a late collision, excessive collision count, or a carrier
sense error.
Displays the number of received packets failed because of an internal MAC
sublayer that is not a late collision, excessive collision count, or a carrier
sense error.
Displays the CRC error. The Cyclical Redundancy Check (CRC) is the 4 byte
field at the end of every frame. The receiving station uses it to interpret if the
frame is valid. If the CRC value computed by the interface does not match the
value at the end of the frame, it's considered a bad CRC.