Figure 4-2 Creating A Profile Using A Device's Mac Address For The Ssid - Motorola MOTOMESH Duo 4300-49 User Manual

2. From a client card utility establish a profile as indicated below. Please read the Important
note below prior to creating a profile. See Figure 2-2 and 2-3 for SSID entry examples.
NOTE: User must specify the SSID manually, read the Important note below. The reason for
the manual entry is because the DUO backdoor access SSID is suppressed.
Please note that if a 2.1 firmware device has been upgraded from a previous
version of 2.0 firmware (Ex: 9.0.51) the previous Web Recovery VAP SSID and
client VAP SSIDs will be preserved. If the upgraded device is then reset back to
factory defaults, the previous default SSID values for the Web Recovery VAP and
client VAPs will be changed to the new 2.1 firmware defaults. The new factory
default SSID value for the Web Recovery VAP is the unique Ethernet MAC
address as found on the device label. The new factory default SSID values for the
client VAP SSIDs are "MOTOMESH-1", "MOTOMESH-2", etc.
When a 4300-xx device (running 2.1 firmware - Ex: 9.1.44 or above) is reset to
factory settings (from a device's Web Interface or WMS), the SSID of VAP 15
operating in 802.11 b/g (the default web recovery VAP) will be changed to
the Ethernet MAC Address (as listed on the device label) of that device (all
CAPS and separated by colons). The SSID of all other VAPs operating in 802.11
b/g or 802.11 a will be changed to MOTOMESH - <VAP index>.
Figure 4-2
May 2008
Creating a Profile Using a Device's MAC Address for the SSID
4-3
MOTOMESH DUO 2.1 4300 Users Guide