Motorola WiNG 5 System Reference Manual page 112

5 - 52 WiNG 5 Access Point System Reference Guide
6. Set the following parameters to define the ARP configuration:
Switch VLAN
Interface
IP Address
MAC Address
Device Type
7. Select the
Select Reset
Figure 5-24 Network - ARP screen
Use the spinner control to select a VLAN for an address requiring resolution.
Define the IP address used to fetch a MAC Address.
Displays the target MAC address that's subject to resolution. This is the MAC
used for mapping an IP address to a MAC address that's recognized on the
network.
Specify the device type the ARP entry supports (Host, Router or DHCP Server).
Host is the default setting.
OK button located at the bottom right of the screen to save the changes to the ARP configuration.
to revert to the last saved configuration.