Table of Contents
Advertisement
8. Set the following for an L2TPv3 profile configuration:
Name
Local IP Address
MTU
Use Tunnel Policy
Local Hostname
Local Router ID
9. Either select
Add
to create a new L2TPv3 configuration,
remove a tunnel from those available to this profile.
Figure 5-123 Network - L2TPv3 screen, T2TP tunnel tab
Displays the name of each listed L2TPv3 tunnel assigned upon creation.
Lists the IP address assigned as the local tunnel end point address, not the
interface IP address. This IP is used as the tunnel source IP address. If this
parameter is not specified, the source IP address is chosen automatically
based on the tunnel peer IP address.
Displays the maximum transmission unit (MTU) size for each listed tunnel. The
MTU is the size (in bytes) of the largest protocol data unit that the layer can
pass between tunnel peers.
Lists the L2TPv3 tunnel policy assigned to each listed tunnel.
Lists the tunnel specific hostname used by each listed tunnel. This is the host
name advertised in tunnel establishment messages.
Specifies the router ID sent in the tunnel establishment messages.
Device Configuration 5 - 223
Edit
to modify an existing tunnel configuration or
Delete
to
Hide quick links:
Advertisement
Table of Contents
