Motorola WiNG 5 System Reference Manual page 181

19. Set the following to define the Dynamic NAT configuration:
Source List ACL
Network
20. Select + Add Row to launch a pop up screen used to define the Interface, Overload Type, Nat Pool and Overload IP
used with the dynamic NAT configuration.
Interface
Figure 5-67 Source ACL List screen
Use the drop-down menu to select an ACL name to define the packet
selection criteria for NAT. NAT is applied only on packets which match a
rule defined in the access-list. These addresses (once translated) will not
be exposed to the outside world when the translation address is used to
interact with the remote destination.
Select Inside or Outside NAT as the network direction for the dynamic NAT
configuration. Inside is the default setting.
Use the drop-down menu to select the VLAN ID (between 1 - 4094) used as
the communication medium between the source and destination points
within the NAT configuration. Ensure the VLAN selected represents the
intended network traffic within the NAT supported configuration. VLAN1 is
available by default. Optionally, select the wwan1 radio button if the
access point model supports a wwan interface as the outgoing layer 3
interface for NAT.
Device Configuration 5 - 121