Table of Contents
Advertisement
12. Refer to the
Peer
table to review the configurations of the peers available for tunnel connection.
Select
+ Add Row
to populate the table with a maximum of two peer configurations.
Figure 5-125 Network - L2TPv3 screen, Add T2TP Peer Configuration
13. Define the following Peer parameters:
Peer ID
Peer IP Address
Host Name
Router ID
Encapsulation
UDP Port
14. Select
OK
to save the peer configuration and overrides.
15. Refer to the
Session
table to review the configurations of the peers available for tunnel connection.
Select
+ Add Row
to populate the table with configurable session parameters for this tunnel configuration.
16. Define the following
Session
Name
Define the primary peer ID used to set the primary and secondary peer for
tunnel failover. If the peer is not specified, tunnel establishment does not
occur. However, if a peer tries to establish a tunnel with this access point, it
creates the tunnel if the hostname and/or Router ID matches.
Select this option to enter the numeric IP address used as the tunnel
destination peer address for tunnel establishment.
Assign the peer a hostname that can be used as matching criteria in the tunnel
establishment process.
Specify the router ID sent in tunnel establishment messages with this specific
peer.
Select either IP or UDP as the peer encapsulation protocol. The default setting
is IP. UDP uses a simple transmission model without implicit handshakes.
If UDP encapsulation is selected, use the spinner control to define the UDP
encapsulation port.
parameters:
Enter a 31 character maximum session name. There is no idle timeout for a
tunnel. A tunnel is not usable without a session and a subsequent session
name.The tunnel is closed when the last session tunnel session is closed.
Device Configuration 5 - 225
Hide quick links:
Advertisement
Table of Contents
