Motorola WiNG 5 System Reference Manual page 218

5 - 158 WiNG 5 Access Point System Reference Guide
5. Either select an access point from those displayed and select Edit, or use the Device Browser in the lower
left-hand side of the UI to select an access point.
6. Select the
Standalone to Virtual Controller AP. Remember that only one Virtual Controller can manage (up to) 24 access
points of the same model. Thus, an administrator should take care to change the designation of a Virtual Controller
AP to Standalone AP to compensate for a new Virtual Controller AP designation.
7. Select the
recognize. While this option may help in the administration and management of all the APs in the network, in does
introduce the risk of allowing device association to a potential rogue device. That's why this setting is disabled
by default.
8. Select OK
needed.
Figure 5-89 Virtual Controller AP Designation screen
Set as Virtual Controller AP
Adopt Unknown APs Automatically
to save the changes. Select
radio button to change the selected access point's designation from
option to allow the Virtual Control to adopt APs it does not
Reset to revert to the last saved configuration. Delete obsolete rows as