Motorola WiNG 5 System Reference Manual page 130

5 - 70 WiNG 5 Access Point System Reference Guide
5. Select IP Routing
6. Select Add Row +
7. Add IP addresses and network masks in the
8. Provide the
9. Refer to the
Static Default Route
Priority
Figure 5-34 Network Routing screen
to enable static routes using IP addresses. This option is enabled by default.
as needed to include single rows with in the static IPv4 route table.
Gateway used to route traffic.
Default Route Priority field and set the following parameters:
Use the spinner control to set the priority value (1 - 8,000) for the default
static route. This is weight assigned to this route versus others that have
been defined. The default setting is 100.
Network column.