Table of Contents
Advertisement
5 - 74 WiNG 5 Access Point System Reference Guide
Router ID
Auto-Cost
Passive Mode on All
Interfaces
Passive Removed
Passive Mode
6. Set the following
Number of Routes
Retry Count
Retry Time Out
Reset Time
7. Set the following
Originate
Always
Metric Type
Route Metric
Select this option to define a router ID (numeric IP address) for this access
point. This ID must be established in every OSPF instance. If not explicitly
configured, the highest logical IP address is duplicated as the router
identifier. However, since the router identifier is not an IP address, it does not
have to be a part of any routable subnet in the network.
Select this option to specify the reference bandwidth (in Mbps) used to
calculate the OSPF interface cost. The default setting is 1.
When selected, all layer 3 interfaces are set as an OSPF passive interface.
This setting is disabled by default.
If disabling Passive Mode on All Interfaces, use the spinner control to select
VLANs (by numeric ID) as OSPF passive interfaces. Multiple VLANs can be
added to the list.
If enabling Passive Mode on All Interfaces, use the spinner control to select
VLANs (by numeric ID) as OSPF non passive interfaces. Multiple VLANs can
be added to the list.
OSPF Overload Protection
Use the spinner controller to set the maximum number of OSPN routes
permitted.
Set the maximum number of retries (OSPF resets) permitted before the OSPF
process is shut down. The available range is from 1 - 32. The default setting
is 5.
Set the duration (in seconds) the OSPF process remains off before initiating
its next retry. The available range is from 1 - 3,600 seconds. The default is 60
seconds.
Set the reset time (in seconds) that, when exceeded, changes the retry count
is zero. The available range is from 1 - 86,400. The default is 360 seconds.
Default
Information:
Select this option to make the default route a distributed route. This setting
is disabled by default.
Enabling this settings continuously maintains a default route, even when no
routes appear in the routing table. This setting is disabled by default.
Select this option to define the exterior metric type (1 or 2) used with the
default route.
Select this option to define route metric used with the default route. OSPF
uses path cost as its routing metric. It's defined by the speed (bandwidth) of
the interface supporting given route.
settings:
Hide quick links:
Advertisement
Table of Contents
