System Configuration Via The Web-Based Interface - Hirschmann MACH 4000 User Manual

Entering the IP Parameters
2.8 System configuration via the
Web-based interface
With the Basics:Network dialog you define the source from which the
Switch gets its IP parameters after starting, and you assign the IP parameters
and VLAN ID and configure the HiDiscovery access.
Figure 16: Network parameters dialog
Under "Mode", enter where the Switch is to obtain its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP serv-
er on the basis of the MAC address of the switch
configuration via
In the DHCP mode, the configuration is via a DHCP server on the ba-
sis of the MAC address or the name of the switch
tem configuration via
In the local mode the net parameters in the switch memory are used.
Basic - L3P
Release 4.0 11/07
2.8 System configuration via the Web-based in-
BOOTP").
DHCP").
(see page 16 "System
(see page 21 "Sys-
25