Adjusting An Image; Zoom/Size/Pan Controls Menu; Filter Controls Menu - Extron electronics DDS 100 User Manual

im Vertrieb von
www.camboard.de
CAMBOARD Electronics
• To reset the selection or adjustment from a menu screen on which F/R
appears above the upper right corner of the flow chart box, press
and release the Freeze/reset button while that screen is displayed.
In the zoom, size, and centering/pan menus, pressing the Freeze/
reset button resets the adjustments for all three of those screens, as
indicated by ZSC F/R in the flow chart.

Adjusting an image

The LCD menus and front panel controls allow you to make adjustments
to the displayed image. This section describes the adjustments.
You can press the front panel cursor buttons (Up, Down, Left, and Right)
to make adjustments or selections from the menu
screens. The menu screens display arrows to indicate
the cursor buttons that apply to that adjustment or
selection.
For example, the size screen indicates that the Up and Down buttons
increase or decrease the vertical (V) size, and the Left
and Right buttons decrease and increase the
horizontal (H) size.
The horizontal filter screen indicates that you can press the Up and
Down buttons to change the filter selection. The
current selection appears in brackets.
You can press the cursor buttons in the default cycle to center the
displayed scaler output image.

Zoom/size/pan controls menu

Zoom — Changes the image between near and far views. Press the Up
cursor button to zoom in, or press the Down button to zoom out.
Size — Increases or decreases the dimensions of the displayed image
vertically and horizontally. Press the Up cursor button to increase
the vertical size of the image, or press the Down button to
decrease the vertical size. Press the Left cursor button to decrease
the horizontal size of the image, or press the Right button to
increase the horizontal size.
Centering/pan — Shifts the physical position of the displayed image
vertically and horizontally. Press the Up cursor button to pan up
the image, or press the Down button to pan down. Press the Left
cursor button to shift the image to the left, or press the Right
button to shift the image to the right.

Filter controls menu

Horizontal filter — Applies one of four available filters to improve the
detail of the image. Press the Up or Down cursor buttons to move
through the filters. Choose the filter that provides the most
improvement to the image detail.
Vertical filter — Applies one of ten available filters to decrease flicker in
the image. Press the Up or Down cursor buttons to move through
the filters. Choose the filter that provides the greatest reduction of
flicker while maintaining image sharpness.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
DDS 100 Operation 3-5