Acura 1994 Integra Service Manual page 587

Differential Carrier Replacement
1 . Remove the final driven gear from the differential
carrier.
NOTE: Tho final driven gear bolts have left-hand
threads.
Pry the snsp ring ofl differential carrier. then remove
the speedometer drive gear 8nd 5 x 1O mm roller.
lnstall th6 5 x 1O mm roller in the differentisl csrrier'
Install the speedom€ter drive gear with its chamfered
side facing the carrier, Align the cutout on the bore
of the speedometer drive gesr with the 5 x 10 mm
roll€r.
5 .
4 .
SPEEDOMETEB
DRIVE GEAR
Instsll in this
diroction.
DRIVE GEAR
5. Align the hooked end of the snap ring with the pin-
ion shaft as shown, then installthe snap ring in the
diff€rential carrior groove.
Hooksd €nd
SI{AP RII{G
Install in this direction.
o .
Install the final driven gear, then tighten the bolts
to th6 spscified torque.
TOROUE: 101 N.m (10.3 kgf.m, 74.5 lbf.ft)
NOTE: The final driven gear bolts have left-hand
threads.
BOLTS
1 0 r 1 . 0 m m
lOi N.m (1O.3 kgf.m,
74.5 tbt'ft)
Left-hand thrgads
7. Install the ball bearings {see page 15-22).
15-23