Acura 1994 Integra Service Manual page 1000

4. Remove the screws.
Detach the harness clip and connector clip.
> : Screw locations, 2
Disconnect the air mix control cable from the heat-
er unrt.
AIR MIX CONTROL
CABLE
AIR MIX CONTROL
CONNECTOR CLIP
HEATER CONTROL
CABLE
2 0 - 1 3 3
Pull the heater control panel out, then disco.rEt rhG
conneclors.
NOTE: Take care not to bend the atr mtx control
cable.
AIR MIX COI{TROL
CABLE
HEATER
CONTROI
PANEL
7, lnstallation is the reverse o{ the removal procedure.
NOTE: Make sure the connector and air mix con-
trol cable are connected properly.
(cont'd)