Installation - Acura 1994 Integra Service Manual

Steering Wheel
Installation
Airbag installation
CAUTION:
. B€fore inrtalling the stooring wheel, align tho front
who6l3 etraight ahead.
. Bo sure to install the harness wires so that thGy are
not pinched or intorfsring with othor car parts.
. Do not roplace thc original stsoring wheel with any
othor design. since it will maks it impo$ibla to prop-
erly install the airbag. {Only use genuine HONDA
replscomont parts)
. After rols3embly. confirm thai the whoels are still
straight ahoad 8nd that steoring wheel spoke anglo
is correct. lf minor spoke anglo adiustment is noc€s-
srry, do so qnly by adlustment ol th€ tie-rods, not by
romoving and repositioning the steering wh€€|.
@
c o n t i r m i h a t t h e a i r b a g a s s o m b l y i s
socurely attachsd to the stooring wheel; oth€rwise,
s c v o r o p o r s o n a l i n i u r y c o u l d r € s u l t d u r i n g a i r b a g
doploym6nt.
1 . B e f o r e i n s t a l l i n g t h e s t e e r i n g w h e e l , c e n t e r t h e
cable reel.
Do this by tirst rotating the cable reel clockwise
until it stoos.
Then rotate it counterclockwise (approximately two
turnsl until:
- The yellow gear tooth lines up with the mark on
the cover.
- The arrow on the cable reel label points straight
U D .
YELI-OW GEAR
ALIGNMENT MARK
17-26
2. Install the steering wheel.
NOTE: Be sure the steering wheel shaft engages
the cable reel and canceling sleeve.
a9 N.m (5.0 ksf'm,36 lbf.ftl
Attach the cruise control sevresume switch€s con-
nector to the steering wheel clip.
Connect ihe horn connector.
CRUISE CONTROL
SET/NESUME SWITCHES
CONNECTOR