Acura 1994 Integra Service Manual page 554

Transmission
Installation {cont'd)
1 4 .
1 5 .
Install new set rings on the end of the intermediate
shaft and the driveshaft.
Install the intermediate shaft.
SET RING
Beplace.
1 6 .
1 0 x 1
3 9 N . m
14.O kgf.m, 29 lbf.ftl
Install exhaust pipe A. and connect the heated oxv-
gen sensor {HO2S) connector.
SELF-LOCKING NUT
1 0 x 1 . 2 5 m m
54 N.m (5.5 kgl.m,
40 rbt.trl
Replace.
GASKET
Replace.
SELF.LOCKING NUTS
I x 1 . 2 5 m m
22 N.m 12.2 kgl'n,
16 lbt.trl
Repl6ce.
SHAFT
1 4 - 1 6 6
DAMPER PINCH BOLT
1 0 x 1 . 2 5 m m
43 N.m 14.4 kgf.m,
32 tbr.ftl
1 7. Install the right and left drivershafts (see section l6l.
NOTE: Turn the right and left steering knuckle fully
outward, and slide the right driveshaft into the
differential until you feel its spring clip engages the
side geaf. Slide the left driveshaft into the intermedi-
ate shaft until you teel the spring clip of the inter-
mediate shaft engage the driveshaft.
18. Install right damper fork, then install the right and
lett balljoints to each lower arm with the castle nuts
and new cotter Dins.
\
COTTER
Replace.
CASTLE NUT
1 2 x 1 . 2 5 m m
4 9 - 5 9 N . m
{5.O-6.0 ksf.m, 36-43
SELF.LOCKING NUT
1 2 x 1 . 2 5 m m
64 N.m (6.5 kgl.h, 47 lbt.ftl
Replace.
rbt'ft1
1 9 . I n s t a l l t h e s p l a s h s h i e l d .
6 x 10 mm BOLT
cltPs, 5