Acura 1994 Integra Service Manual page 929

Hide thumbs Also See for 1994 Integra:

Table of Contents

lnstallation

Scrape the old adhesive smooth with a knife to a

thickness of about 2 mm (O.O8 in) on the bonding

surface around the entire rear window opening

a Do not scrape down to the painted surface of the

body; damaged paint will interfere with proper

a Remove the upper and lower fasteners trom the

a Mask otf surrounding surtaces before applying

Clean the hatch bonding surface with a sponge

dampened in alcohol.

NOTE: After cleaning, keep oil, grease or water trom

getting on the surface.

lI the old rear window is to be reinstalled, use a put-

ty knile to scrape ott all traces ot old adhesive, then

clean the rear window surface with alcohol where

new adhesive is to be applied.

NOTE: Make sure the bonding surface is kept tree

of water, oil and grease.

CAUTION: Avoid s€tting ths rear window on its

edges; small chips may lator devalop into cracks,

NOTE: Clean the shadowed area,

Apply the upper seal to the inside face of glass as

Glue the upper tasteners, lower fasteners and side

spacers, to the inside tace ot the rear window on

F A S T E N E R , 2

G||le the lower fasteners and upper Jasteners to the

hatch, as shown.

Show Quick Links

Chapters

Table of Contents