Acura 1994 Integra Service Manual page 924

4 . Center and glue the upper molding to the upper edge
of the windshield.
ALIGNMENT MARK
GIue the uDDer and lower rubber dams to the inside
face ot the windshield, as shown, to contain the
adhesive during installation,
NOTE: Be careful not to touch the windshield where
adhesive will be applied.
UPPER RUBBER UPPER MOLDING
12 mm {0.47 inl
DAM
1O mm 10.39 ln)
6. Install the glsss brackets and retainers as shown.
NOTE: The numbers atter the pan names show the
quantities of the psrts used.
BRACKET, 2
7.
Set the windshield on the glass brackets, then center
it in the opening. Make alignment marks across the
windshield and body with a grease pencilat the four
points shown.
ALIGNMENT MARK
8. Remove the windshield.
20-57