NOTE:
a Clean all parts thoroughly in solvent o. carburetor
cleaner and d.y with compressed air.
a Blow out all passages.
a When removing the transmission housing, replace the
following:
. Transmission housing gasket
. Lock washer
1. Remove the transmission mount b.acket.
Remove the transmission housing mounting bolts
and hanger.
Align the spring pin of the control shaft with the
transmission housing groove by turning the control
shaft.
Install the special tool on the transmission housing,
then remove the housing as shown.
HOUSING PUI-LER
07HAC-PK4010A
2 .
4 .
6 .
Remove the countershaft reverse gear with the col-
lar and needle bearing.
Remove the lock bolt securing the shitt fork. then
remove the fork with the reverse selector trom the
countershatt.
Remove the countershaft and mainshaft sub-
assembly together.
8.
Remove the ditferential assemblv.
14-113