Acura 1994 Integra Service Manual page 657

Steering Gearbox
Disassembly (cont'dl
25. Using a cutter or an equivalent tool, cut and remove
the four seal rings from the sl6eve.
CAUTION: Bc clroful not to drmrg.
ths .dgc. ot
thc alcava g1oov6 whan rcmoving the 3cd rings
lnd O.ring.
Using a cutter or an gquivalent tool, cut the valve
seal ring and O-ring Et the groove the pinion shaft.
Remove the valv€ saal ring 8nd O-ring,
CAUTION: Br crrltul not to drm.gr
thc cdgct of
thc plnion rhdt grooya whcn rcmoving the vllvc
!.!l ring rnd O-ring.
26.
SI-EEVE
Cutting slot position.
17.52
Remova the valve oil seal 8nd backup ring from the
pinion shaft.
NOTE:
.
Inspect the ball bearing by rotating the outer
race slowly. lf thsre is excessive play, replace the
pinion shaft and sleeve as an assembly.
. The pinion shaft and sleeve are a precise fiu do
n o t i n t e r m i x o l d a n d n e w p i n i o n s h a f t s a n d
steev8s,
28, Press th6 valve oil s€al and roller besring out ofthe
valve housing using a hydraulic press and special
tool shown below.
PILOT COLLAR
O?GAF - PHTO1OO