Acura 1994 Integra Service Manual page 1029

Door and Side Moldings
Replacement
CAUTION: When prying with 8 flal tip screwdriver, wrap it with
protective tape to pr€vont damag€'
NOTE:
a To remove the doot moldlng, temove the door panel and plastic cover {see
pages 2O-4' 2O' 32],'
a To remove the rear side molding, remove the side trim panel
(see page 20-91)
a Take care not to bend the door moldings.
a The steel core in the door molding cann-ot be restored to its original shape once it
is bent. Replace the door molding
if the steel core is bent.
V : Clip locations
av : cllp (Hatchb6ck, 5)
BV: clip (Hatchback' 3)
V: Plastic nui locatlon
(Hatchback, 1)
(Sedan, 1)
CV: Cllp (Halchback, 1l
{Sodan,2l
Dv: Clip lsodan, 1)
Hatchbsck
20-162
30 mm
( 1 . 1 8 i n l
lnstallation is the reverse
NOTE: It necessary,
oJ the removal Procedure.
replace any damaged cliP.
NEW ADHESIVE TAPE
Thicknoss: 1.2 mm lo.o5 inl
Forward
STEEL
CLIP
O '
l r >
r9
NOTE:
a BeJore instatling the rear door molding,
scrape the adhesive tape from the mold-
ing and body.
a Clean the motding and door bonding sur-
Jaces with a sponge dampened in alcohol'
a Atter cleaning, keep oil, grease and water
Jrom getting on the surface.
a Glue the new adhesive tape to the mold-
ing as shown.
6 m m
3 0 m m
ls 2f 61 . t.l.18 inl
REAR DOOR
MOLDING