Pressure Plate; Removal/Lnspection - Acura 1994 Integra Service Manual

Pressure Plate
RING GEAR HOLDER
07LAB-PVOOl OO or
07924-PD20003
Removal/lnspection
Check the diaphragm spring fingers for height us-
ing the special tools and a feeler gauge.
Standard lNew): 0.6 mm (0.02 inl Max.
Service Limit: O.8 mm {O.O3 in}
FEELER GAUGE
07NAF-PR30100
0 7 9 3 6 - 3 7 1 0 1 0 0
. lf the height is more than the service limit, replace
the pressure plate.
2. Install the special tools.
3. To prevent warping, unscrew the pressure plate
mounting bolts in a crisscross pattern in several
steps, then remove the pressure plate.
CLUTCH ALIGNMENT SHAFT
07NAF-PR30100
HANDLE
07936-3710'l OO
PRESSURE PLATE
CLUTCH ALIGNMENT OISC
O T J A F _ P M 7 0 1 1 A
4 .
Inspect the pressure plate surface
and burning.
Inspect the fingers of the diaphrag
at the release bearing contact ar
DIAPHRAGM SPRING
Inspect for warpage using a stru
er gauge.
NOTE: Measure across the prer
pornls.
Standard (Newl: 0.03 mm (0.0
Sorvice Limit:0.15 mm (0.0O6
STRAIGHT EOGE
FEELER GAUGE
PI
lf the warpage is more than
replace the pressure plate.
6 .
I surface for wear, cracks,
diaphragm spring for wear
nracr area.
PRESSURE PLAT€
straight edge and feef
pressure plate at three
0 . 0 0 1 i n ) M a x .
)O6 inl
1 2 - 7