Lnstallation - Acura 1994 Integra Service Manual

lnstallation
Installthe cylinder head in the reverse order of removal:
NOTE:
. Always use a new head and manifold gasket.
. The cylinder head gasket is a metal gasket Take care
not to bend it.
.
Rotate the crankshaft, set the No. 1 piston at TDC
(page 6-51).
.
D o n o t u s e t h e m i d d l e c o v e r a n d l o w e r c o v e r f o r
storing items disassembled.
. Clean the middle cover and lower cover before instal-
lation.
a Replace the washer when damaged or deteriorated
1. tnstall the cylinder head gasket. dowel pins and the
head oil control orifice on the cylinder head
NOTE: Clean the oil control orifice when installing.
O.RING
Replace.
HEAD
OIL CONTROL
ORIFICE
Cloan.
2. Tighten cylinder head bolts in two steps. In the first
step, tighten all bolts in sequence to about 29 N'm
( 3 . 0 k g f . m . 2 2 l b f ' f t ) . I n t h e f i n a l s t e p , t i g h t e n i n
same sequence to 81 N.m (8.3 kgnm.60 lbf'ft).
NOTE: Apply clean engine oil to the bolt threads
and under the bolt head.
CYLINDER HEAD BOLT TOROUE SEOUENCE
1 1 x 1 . 5 m m
81 N.m {8.3 kgf.m,60 lbf ft)
Install the intake manifold and tighten the nuts in a
crisscross pattern in two or three steps, beginning
with the inner nuts.
GASKET
R e P l a c e
8 x 1.25 mm
23 N.m 12.3 kgl.m.
17 tbf.ftt
8 x 1.25 mm
24 N,m 12.,4 kgf m,
17 tbf.ft)
(cont'd)
6-75