Acura 1994 Integra Service Manual page 1016

20 mm (O.79 inl
SUPPORT STRUT
Support Strut Disposal
@
Tha support strut contains nitrog.n gas and
oil unde. pr€ssul€.
The pressure must be relieved bsfo.e disposal to prevant
explosion and possible injury wh€n sc.apping.
Place the support strut on a level surface with its rod ex-
tended, and drilla hole 2-3 mm (3/32"1diameter in the
body to release the gas.
@
always w€ar €ye prot6ction to avoid get-
ting motal shavings in your eyea when roloasing th€ gas
fiom the support st.ut.
Trunk Lid
TRUNK LID
OPEN€R CABLE
TRUNK LID
LATCH
{see page 20-157}
TRUNK LIO
OPENER
CABLE
CA : Clip, 5
e-i
_ r P , /
Replacement
NOTE:
a An assistant is helpful when removing the trunk lid.
a Take care not to damage the t.unk lid and body.
a Open the trunk lid.
1. Disconnect the connectors and trunk lid opener ca-
ble. Remove the wire harness and t.unk lid opner ca-
ble from the trunk lid.
NOTE: Before pulling out the wire harness, tie a
string to the end ot it so you can pull it back in when
the trunk lid is reinstalled.
> : Clip locationg
AD : Clip, 3
B< : Clip, 1
WIRE HARNESS
CONNECTOR CONIIECTOR
A
A
(cont'd)
20-149