Installation (engine removal not
S€AL DRIVEB
07LAD - PRimroA
lnstallse6lwith tho
Pan number
tacing out.
Using the special tool, drive in the flywheel-end seal
until the driver bottoms against block.
NOTE: Align the hole in the drivsr attachment with
the Din on the crankshaft.
Oil Seal
required)
The seal surface on the block should b€ dry.
Apply a light coat of grease to the crankshaft and
to the lio of seal.
Using the special tool, drive in the timing pullsy-
end seal until the driver bottoms against the oil
pump.
When the seal is in place, clean any excess grease
off lhe crankshaft and check that the oil seal tiD is
not distoned.
7-26