Acura 1994 Integra Service Manual page 1062

Heater Valve Gable
Adjustment
Disconnect the heater valve cable from the heater
valve arm and the clamp, and from the heater con-
trol arm and the clamp.
Set the temperature control lever to MAX. HEAT.
Turn the heater control arm as shown. and connect
the end of the heater valve cable to the heater con-
trol arm.
Gently slide the heater valve cable housing back from
the end enough to take up any slack in the heater
valve cable, but not enough to make the tempera-
ture control lever move. Hold the end of the heater
valve cable housing against the stop, then snap the
heater valve cable housing into the clamp.
2 .
Air Mix Control Cable
Adjustment
'l
. Disconnect the air mix control cable from the air max
control arm and the clamp.
2. Set the temperature control lever to MAX, HEAT.
3, Turn the air mix control arm as shown. and connect
the end of the air mix cont.ol cable to the air mix
control arm.
4. Gently slide the air mix control cable housing back
trom the end enough to take up any slack in the air
mix controlcable, but not enough to make the tem-
pe.ature control lever move, then snap the air mix
control cable housing into the clamp.
NOTE: The heater valve cable should always be ad-
justed whenever the air mix control cable has been
disconnected.
HEATER COIITBOL
ARM
HEATEB VALVE
CABLE
AIR MIX CONTROL
CABLE
AIB MIX CONTROL
ARM
5. Turn the heate. valve arm as shown, and connect
the end of the heater valve cable to the heater valve
a r m .
Gently slide the heater valve cable housing back from
the end enough to take up any slack in the heater
valve cable, but not enough to make the tempera-
ture control lever move, then snap the heater valve
cable housing into the clamp,
NOTE: The air mix control cable should always be
adjusted whenever the heater valve cable has been
disconnected.
CLAMP
2 1 - 2 7