Acura 1994 Integra Service Manual page 504

NOTE:
a Clean all parts thoroughly in solvent or carbuetor
cleaner and dry with compressed air.
a Blow out all passages.
a When removing the valve body replace the following:
. O-rings
. Lock wsshers
1 . Remove the oil feed pipes from the servo body, s€r-
vo detent base, accumulatof cover, lock-uD valve
body and main valve body.
2, Remove the three bolts securing the ATF strainer and
servo detent base, then remove them.
3. Remove the three bolts securing the accumulator
cover. then remove the accumulator cover.
4. Remove the six bolts secu.ing the servo body, then
remove the servo body and separator plate.
5. Remove the bolt securing the secondary valve body,
then remove the secondary valve body and separa-
tor plate.
6. Remove the eight bolts securing the lubricator plate
and lock-up valve body, then remove the lubricator
plate, lock-up valve body and separator plate.
7. Femove the bolt securing the.egulator valve body,
then.emove the regulator valve body.
8. Remove the stator shaft and stopper shaft.
9. Remove the detent spring t,om the detent arm. then
remove the control shaft from the torque convener
housing.
1O. Remove the detent arm and detent afm shaft t.om
the main valve bodv.
1 1 . Remove the four bolts secu.ing the main valve body,
then remove the main valve body.
12. Remove the oil pump driven gear shaft, then remove
the oil pump gears.
'13.
Remove the main separator plate with two dowel
Dtns.
14, Remove and clean the ATF magnet.
1 5 .Clean the inlet opsning of the ATF strainer thorough-
ly with compressed air, then check that it is in good
condition, and the inlet opening is not clogged.
II{LET OPENING
Replace the ATF strainer it it is clogged or damaged.
NOTE: The ATF strainer can be reused if it is not
clo9ged.
1 6 .
14-115