Acura 1994 Integra Service Manual page 960

8. Remove the upper anchor bolts from the front and
rear seat belts (see pages 20-1 15, 1 19).
9. Remove the door trim.
NOTE: When installing the door trim, align it with
1O. Remove the quarter tiim and coat hanger fleft sidel.
: Screw locstions, 'l
P r y l h e l i d .
the door opening flange notch.
11. Remove the quarter pillar trim panel.
> : Clip locations
A > : C l i p , 7 B t r : C l i p . 3
S ; +
)
NOTE: Remove the front seat belt lrom
9 U r O e .
the belt
BELT
'12.
Installation is the reverse of the removal procedure.
NOTE:
a lf necessary, .eplace any damaged clips.
a When installing the side trim panel, make sure
there are no twists or kinks in the front and rear
seat belts.
a When installing the rear trim panel, installthe clip
as follows.
- 1 I Pull the inner clip up as shown.
t
Q-.-INNER
./ilk
cLrP
( \c4z )
\/
t l
\#
-2) Install the clip in the rear trim panel. then
push the inner clip until it's flush.
INNER CLIP
20-93