Acura 1994 Integra Service Manual page 954

Motor, Drain Tube and Frame Replacement
CAUTION: Be carotul not to damago th€ seats, dash-
board and other int6rior trim,
1. Remove the glass (see page 2O-86) and headliner
(see page 20-10O).
Disconnect the motor connector, and remove the
clips securing the ceiling light wire harness.
NOTE: To remove the motor, remove the screws.
Disconnect the drain tubes.
Loosen the front bolts.
Remove the bolts, then remove the trame from the
car.
NOTE:
a You may require assistance when removing the
trame.
a Take care not to bend the sunshade rails.
TUBE
CLIP
DRAIN TUBE
To install, slade the drain tube ov6r
the frame nozzle at least 10 mm lO.4 in).
SUNSHADE
RAILS
Pullthe drain tubes out of the tront and rear oillars.
NOTE: Before pulling out the drain tube, tie a string
to the end of it so it can be reinstalled.
Installation is the reverse of the removal grocedure.
NOTE:
a Install the tube clips with the ends facing the side to ease
a Clean the surtace of the frame.
a Check the frame seal.
a Check for water leaks.
a Make sure the sunshade moves smoothlv.
SCREW
4 .
\/
Make sure the sliders are
parallel when installing the
motor,
CONNECTOR
FRAME
BOLT
6 x 1 . 0 m m
9.8 N.m (1.O lg{.rn.
7.2 tbt.ttl
Loosen the tront bohs
Fo?w!?d
t t .
FRONT
DRAIN VALVES
installation of the headliner.
20-87