Acura 1994 Integra Service Manual page 938

ALIGT{MENT MARKS
S
8. Set the rear window, then center it in the opening.
Make alignment marks across the rear window and
body with a gfease pencil at the tout Doints shown.
9. Remove the rear window.
O. With a sponge, apply a light coat of glass primer
around the edge of the rear window as shown, then
lightly wipe it otf with gauze or cheesecloth.
N O T E :
a Do not apply body primer to the rear window, and
do not get body and glass primer sponges mixed
up.
a Never touch the primed surfac€s with your hands.
lf you do, the adhesive may not bond to the rear
window prope.ly, causing a leak after the rear
window is installed.
a Keep water. dust, and abrasive materials awav
f,om the D.imed surtace.
72/:
Appl,t gltst onmrr sctc.
All around.
10 mm lO.4 inl
/.s
s
20-71
1 1. With a sponge. appty a light coat ot body primer ro
the original adhesive remaining around the rear win-
dow opening flange. Let the body p.imer d.y tor at
least 10 minutes.
NOTE:
a Do not apply glass primer to the body, and be
careful not to mix up glass and body primer
sponges.
a Never touch the primed surfaces with vour hands.
l//////1,: appv body p'imo' hero.
;o:d:';", i"lT
16 mm 10.63 inl
6 mm 10.23 inl
16 mm 10.63 inl
12. Thoroughly mix the adhesive and hardener together
on a glass or metal plate with a putty knife. Fo ow
the instructions that came with the adhesive.
NOTE: Clean the plate with a sponge and alcohol
before mixing.
13. Before filling a cartridge, cut the end of the nozzle,
as shown.
10 mm (0.39 in)
7 mm (0.27 inl
{cont'd)